RADIATOR > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for Pre Runner and 4WD Type) |
Remove the 4 bolts, then remove the engine under cover No. 1.
| 3. DRAIN ENGINE COOLANT |
Remove the 4 bolts, then remove the engine under cover No. 1. (PRE RUNNER AND 4WD TYPE)
![]() |
Install a vinyl hose onto the radiator side.
![]() |
Install a vinyl hose onto the engine side.
![]() |
Loosen the engine drain plug.
Loosen the radiator drain plug.
Remove the radiator cap and drain coolant.
Drain the coolant from the reservoir tank.
| 4. REMOVE RADIATOR SUPPORT TO FRAME SEAL LH |
![]() |
Disengage the 9 clips, then remove the radiator support to frame seal LH.
| 5. REMOVE FAN SHROUD |
![]() |
Loosen the 4 nuts shown in the illustration.
Remove the fan and generator V belt.
![]() |
Disconnect the radiator reserve tank hose from the radiator.
![]() |
Disconnect the oil cooler inlet and outlet hoses from the fan shroud. (for Automatic Transmission)
![]() |
Remove the 2 bolts shown in the illustration.
![]() |
Remove the 4 nuts, then remove the fan shroud and fan with fluid coupling together.
![]() |
Remove the fan pulley.
| 6. REMOVE RADIATOR ASSEMBLY |
![]() |
Disconnect the radiator hose inlet.
![]() |
Disconnect the radiator hose No. 2.
![]() |
Disconnect the oil cooler inlet and outlet hoses. (for Automatic Transmission)
Remove the 4 bolts, then remove the radiator.
