BRAKE ACTUATOR (w/o VSC) > ON-VEHICLE INSPECTION |
| 1. CONNECT INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Start the engine and allow it to idle.
Select ACTIVE TEST mode on the intelligent tester.
| 2. INSPECT ACTUATOR MOTOR OPERATION |
With the motor relay ON, check the actuator motor operation noise.
Turn the motor relay OFF.
Depress the brake pedal and hold it for about 15 seconds. Check that the brake pedal cannot be depressed.
With the motor relay ON, check that the pedal does not pulsate.
Turn the motor relay OFF and release the brake pedal.
| 3. INSPECT RIGHT FRONT WHEEL OPERATION |
With the brake pedal depressed, perform the following operations.
Turn SFRH and SFRR solenoids ON simultaneously, and check that the pedal cannot be depressed.
Turn SFRH and SFRR solenoids OFF simultaneously, and check that the pedal can be depressed.
Turn the motor relay ON, and check that the pedal returns.
Turn the motor relay OFF and release the brake pedal.
| 4. INSPECT OTHER WHEEL OPERATION |
Check the solenoids of the other wheels using the same procedures as above.