Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Entire Combination Meter does not Operate

for Preparation Click here


WIRING DIAGRAM


B125010E02


INSPECTION PROCEDURE

1.CHECK FUSE


    I101305E02
  1. Remove the ECU-B fuse, AM2 fuse and short pin from the engine room R/B.

  1. Remove the GAUGE fuse from the driver side J/B.

  1. Measure the resistance.

    Standard Resistance:
    Below 1 Ω

  1. Reinstall the fuses and short pin.



NG
INSPECT FOR SHORT CIRCUIT IN HARNESS AND ALL COMPONENTS CONNECTED TO FUSE
OK


2.INSPECT COMBINATION METER ASSEMBLY


    I044513E12
  1. Disconnect the C9 combination meter connector.

  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    C9-2 - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    C9-1 - Body ground
    Always
    10 to 14 V
    C9-21 - Body ground
    Ignition switch ON
    10 to 14 V

  1. Reconnect the combination meter connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY