Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Fuel Gauge Malfunction

for Preparation Click here


WIRING DIAGRAM


B125036E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR


    I044524E01
  1. Disconnect the F19 fuel sender gauge connector.

  1. Check the meter indicator conditions.

    Standard:
    Wire Connection
    Condition
    Specified Condition
    2 - 3
    Short circuit
    (Ignition switch ON)
    Fuel gauge indicates "F" or more (Combination meter)

  1. Measure the voltage.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    2 - Body ground
    Ignition switch ON
    4 to 7 V

    NOTICE:
    1. Perform the check quickly (shorter than 10 seconds).
    2. Keep the battery as far away from the fuel pump as possible.
    3. Always do the switching at the battery side.

  1. Reconnect the fuel sender gauge connector.



NG
Go to step 3
OK


2.INSPECT FUEL SENDER GAUGE ASSEMBLY


    I045520E01
  1. Remove the fuel sender gauge assembly.

  1. Check that the float position is between E and F.

  1. Measure the resistance between terminals 2 and 3 of the fuel sender gauge connector.

    Standard Resistance:
    Float Level
    Float Position (mm (in.))
    Specified Condition
    F
    81.5 (3.21) to 86.5 (3.41)
    5.0 to 6.0 Ω
    1/2
    3.4 (0.13)
    59.0 Ω
    Warning
    80.4 (3.17)
    98.8 Ω
    E
    97.9 (3.85) to 102.9 (4.05)
    107.5 to 112.5 Ω

  1. Reinstall the fuel sender gauge assembly.



NG
REPLACE FUEL SENDER GAUGE ASSEMBLY
OK

REPLACE COMBINATION METER ASSEMBLY 

3.CHECK HARNESS AND CONNECTOR (FUEL SENDER GAUGE - COMBINATION METER ASSEMBLY)


    I101311E01
  1. Disconnect the C9 combination meter connector.

  1. Disconnect the F19 fuel sender gauge connector.

  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    C9-4 - F19-3
    Below 1 Ω
    C9-8 - F19-2
    Below 1 Ω
    C9-4 or F19-3 - Body ground
    10 kΩ or higher
    C9-8 or F19-2 - Body ground
    10 kΩ or higher

  1. Reconnect the fuel sender gauge connector.

  1. Reconnect the combination meter connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY