Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Driver Side Seat Belt Warning Light does not Operate

for Preparation Click here


WIRING DIAGRAM


B125015E01


INSPECTION PROCEDURE

HINT:
Confirm that other components such as indicators and meter gauges function normally before performing the following procedure.

1.CONFIRM SEAT TYPE
  1. Confirm the seat type.
    Seat Type
    Proceed To
    Bench seat
    A
    Separate seat
    B



B
Go to step 4
A


2.INSPECT FRONT SEAT INNER BELT ASSEMBLY (DRIVER SIDE)


    I045519E01
  1. Disconnect the F22 front seat inner belt assembly (driver side) connector.

  1. Measure the resistance.

    Standard Resistance:
    Terminal Connection
    Condition
    Specified Condition
    1 - 2
    Seat belt fastened
    10 kΩ or higher
    1 - 2
    Seat belt unfastened
    Below 1 Ω

  1. Reconnect the front seat inner belt assembly (driver side) connector.



NG
REPLACE FRONT SEAT INNER BELT ASSEMBLY (DRIVER SIDE)
OK


3.CHECK HARNESS AND CONNECTOR (FRONT SEAT INNER BELT (DRIVER SIDE) - COMBINATION METER)


    I101312E01
  1. Disconnect the C9 combination meter connector.

  1. Disconnect the F22 front seat inner belt assembly (driver side) connector.

  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    C9-10 - F22-2
    Below 1 Ω
    C9-10 or F22-2 - Body ground
    10 kΩ or higher

  1. Reconnect the front seat inner belt assembly (driver side) connector.

  1. Reconnect the combination meter connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY 

4.INSPECT FRONT SEAT INNER BELT ASSEMBLY (DRIVER SIDE)


    I045523E01
  1. Disconnect the F21 front seat inner belt assembly (driver side) connector.

  1. Measure the resistance.

    Standard Resistance:
    Terminal Connection
    Condition
    Specified Condition
    1 - 2
    Seat belt fastened
    10 kΩ or higher
    1 - 2
    Seat belt unfastened
    Below 1 Ω

  1. Reconnect the front seat inner belt assembly (driver side) connector.



NG
REPLACE FRONT SEAT INNER BELT ASSEMBLY (DRIVER SIDE)
OK


5.CHECK HARNESS AND CONNECTOR (FRONT SEAT INNER BELT (DRIVER SIDE) - COMBINATION METER)


    I101313E01
  1. Disconnect the C9 combination meter connector.

  1. Disconnect the F21 front seat inner belt assembly (driver side) connector.

  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    C9-10 - F21-2
    Below 1 Ω
    C9-10 or F21-2 - Body ground
    10 kΩ or higher

  1. Reconnect the front seat inner belt assembly (driver side) connector.

  1. Reconnect the combination meter connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY