Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST
  1. By reading the DATA LIST displayed on the intelligent tester, you can check values, including those of the switches, sensors, actuators without removing any parts. Reading the DATA LIST as the first step of troubleshooting is one method of shortening diagnostic time.

    1. Warm up the engine.

    2. Turn the ignition switch OFF.

    3. Connect the intelligent tester to the DLC3.

    4. Turn the ignition switch to the ON position.

    5. Operate the intelligent tester according to the display and select "DATA LIST".


ECM : 
Item
Measurement Item/ Range (Display)
Normal Condition
Diagnostic Note
VEHICLE SPEED
Vehicle speed/
Min.: 0 mph (0 km/h), Max.: 153 mph (255 km/h)
Almost same as actual vehicle speed (When driving)
-
ENGINE SPD
Engine speed/
Min.: 0 rpm, Max.: 16,383 rpm
Almost same as actual engine speed (When engine is running)
-
COOLANT TEMP
Engine coolant temperature /
Min.: -40°C (-40°F), Max.: 140°C (284°F)
After warning up:
80 to 95°C (176 to 203°F)
If value is -40°C (-40°F), sensor circuit is open.
If value is 140°C (284°F), sensor circuit is shorted.