POWER DOOR LOCK CONTROL SYSTEM > Key Lock-in Prevention Function does not Work Properly |

| 1.CHECK HARNESS AND CONNECTOR (DRIVER SIDE JUNCTION BLOCK - BODY GROUND) |
![]() |
Disconnect the 1K driver side J/B connector.
Measure the resistance.
| Tester Connection | Connection | Specified Condition |
| 1K-10 (KSW) - Body ground | No key in ignition key cylinder | 10 kΩ or higher |
| 1K-10 (KSW) - Body ground | Key inserted in ignition key cylinder | Below 1 Ω |
Reconnect the driver side J/B connector.
|
| ||||
| NG | |
| 2.INSPECT UNLOCK WARNING SWITCH ASSEMBLY |
![]() |
Remove the unlock warning switch.
Measure the resistance.
| Tester Connection | Switch Connection | Specified Condition |
| 1 - 2 | Not pushed | 10 kΩ or higher |
| 1 - 2 | Pushed | Below 1 Ω |
Reinstall the unlock warning switch.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SWITCH ASSEMBLY - DRIVER SIDE J/B ASSEMBLY AND BODY GROUND) |
![]() |
Disconnect the U1 unlock warning switch connector.
Disconnect the 1K driver side J/B connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| U1-1 - 1K-10 (KSW) | Below 1 Ω |
| U1-2 - Body ground | Below 1 Ω |
Reconnect the unlock warning switch connector.
Reconnect the driver side J/B connector.
|
| ||||
| OK | |
| 4.CHECK FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (DRIVER SIDE) |
Move the room light switch to the DOOR position and open the driver side door. Check that the room light turns ON.
|
| ||||
| NG | |
| 5.INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (DRIVER SIDE) |
![]() |
Remove the front door courtesy light switch assembly.
Measure the resistance of the switch.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - Body ground | Not pushed (ON) | Below 1 Ω |
| 1 - Body ground | Pushed (OFF) | 10 kΩ or higher |
Reinstall the front door courtesy light switch assembly.
|
| ||||
| OK | |
| 6.CHECK HARNESS AND CONNECTOR (SWITCH ASSEMBLY (DRIVER SIDE) - DRIVER SIDE J/B ASSEMBLY) |
![]() |
Disconnect the D11 front door courtesy light switch connector.
Disconnect the 1F driver side J/B connector.
Measure the resistance.
| Tester Connection | Specified Condition |
| D11-1 - 1F-7 (DCTY) | Below 1 Ω |
Reconnect the front door courtesy light switch connector.
Reconnect the driver side J/B connector.
|
| ||||
| OK | ||
| ||