AUTOMATIC TRANSMISSION SYSTEM > CHECK MODE PROCEDURE |
| DESCRIPTION |
| CHECK MODE PROCEDURE |
![]() |
Ensure the following conditions:
Battery positive voltage 11 V or more
Throttle valve fully closed
Transmission in the P or N position
A/C switched OFF
Turn the ignition switch off.
Connect the intelligent tester together with the Controller Area Network Vehicle Interface Module (CAN VIM) to the DLC3.
Turn the ignition switch to the ON position.
Enter the following menus: DIAGNOSIS/ ENHANCED OBD II/ CHECK MODE.
![]() |
Change the ECM to check mode. Make sure the MIL flashes as shown in the illustration.
Start the engine. The MIL should turn off after the engine starts.
Perform "MONITOR DRIVE PATTERN" for the ECT test. (Click here).
(Or, simulate the conditions of the malfunction described by the customer).
After simulating the malfunction conditions, use the intelligent tester diagnosis selector to check the DTC and freeze frame data.