AUTOMATIC TRANSMISSION SYSTEM > MECHANICAL SYSTEM TESTS |
| STALL SPEED TEST |
Connect the intelligent tester to the CAN VIM. Then connect the CAN VIM to the DLC3.
Run the vehicle until the transmission fluid temperature has reached 50 to 80°C (122 to 176°F).
Allow the engine to idle with the air conditioning OFF.
Chock all 4 wheels.
Set the parking brake and keep the brake pedal depressed firmly with your left foot.
Shift the shift lever into the drive position.
Depress the accelerator pedal as much as possible with your right foot.
Read the engine rpm (stall speed) and release the accelerator pedal immediately.
| Test Result | Possible Cause |
| Stall speed is lower than standard value |
|
| Stall speed is higher than standard value |
|
| SHIFT TIME LAG TEST |
Connect the intelligent tester to the CAN VIM. Then connect the CAN VIM to the DLC3.
Run the vehicle until the transmission fluid temperature has reached 50 to 80°C (122 to 176°F).
Allow the engine to idle with the air conditioning OFF.
Set the parking brake and keep the brake pedal depressed firmly.
Check the D range time lag.
Shift the shift lever into the N position and wait for 1 minute.
Shift the shift lever into the D position and measure the time until the shock is felt.
Repeat the 2 procedures above 3 times, and calculate the average time of the 3 tests.
Check the R range time lag.
Shift the shift lever into the N position and wait for 1 minute.
Shift the shift lever into the R position and measure the time until the shock is felt.
Repeat the 2 procedures above 3 times, and calculate the average time of the 3 tests.
| Test Result | Possible Cause |
| D range time lag exceeds standard value |
|
| R range time lag exceeds standard value |
|