AUTOMATIC TRANSMISSION SYSTEM > HYDRAULIC TEST |
| PERFORM HYDRAULIC TEST |
Measure the line pressure.
![]() |
Warm up the ATF.
Lift the vehicle up.
Remove the test plug on the transmission case center right side and connect SST.
Fully apply the parking brake and chock the 4 wheels.
Start the engine and check the idling speed.
Keep your left foot pressing firmly on the brake pedal and shift into the D position.
Measure the line pressure while the engine is idling.
Depress the accelerator pedal all the way down. Quickly read the highest line pressure when the engine speed reaches the stall speed.
In the same manner, do the test in the R position.
| Condition | D position: kPa (kgf / cm2, psi) | R position: kPa (kgf / cm2, psi) |
| Idling | 363 to 422 (3.7 to 4.3, 52.6 to 61.2) | 608 to 706 (6.2 to 7.2, 88.2 to 102.4) |
| Stall test | 932 to 1,177 (9.5 to 12.0, 135.2 to 170.7) | 1,569 to 1,912 (16.0 to 19.5, 227.6 to 277.3) |
| Problem | Possible cause |
| If the measured values at all positions are too high |
|
| If the measured values at all positions are too low |
|
| If pressure is low in the D position only |
|
| If pressure is low in the R position only |
|