DTC P0604 Internal Control Module Random Access Memory (RAM) Error |
DTC P0606 ECM / PCM Processor |
DTC P0607 Control Module Performance |
DTC P0657 Actuator Supply Voltage Circuit / Open |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P0604 P0606 P0607 P0657 | ECM internal error (1 trip detection logic) | ECM |
| Related DTCs | P0604: ECM RAM error P0606: ECM range check P0607: ECM CPU malfunction P0657: ETCS power supply |
| Required Sensors/Components (Main) | ECM |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | P0604: 6 times or more P0606: Within 16 seconds P0607 and P0657: Within 1 second |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | None |
| RAM mirror check | fail |
| Either of following conditions met: | - |
| Difference between throttle valve position of main CPU and throttle valve position of sub CPU | 0.3 V or more |
| Difference between accelerator pedal position of main CPU and accelerator pedal position of sub CPU | 0.3 V or more |
| Either A or B met | - |
| A. Following conditions met | |
| CPU reset | 1 time or more |
| Learned TP - learned APP | 0.4 V or more |
| Throttle actuator | OFF |
| B. CPU reset | 2 times or more |
| ETCS (Electronic Throttle Control System) power supply when ignition switch turned ON | 7 V or more |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0604/P0606/P0607/P0657) |
Connect an intelligent tester to the DLC3.
Turn the ignition switch ON.
Turn the tester ON.
Enter the following menus: DIAGNOSIS / ENHANCED II / DTC INFO / CURRENT CODES.
Read the DTC.
| Display (DTC output) | Proceed to |
| P0604, P0606, P0607, P0657 | A |
| No output DTC | B |
|
| ||||
| A | ||
| ||