Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > Steering Angle Sensor Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
STEERING ANGLE SENSOR COMMUNICATION STOP MODE
  1. "STEERING SENSOR" is not displayed on the "Bus Check "screen of the intelligent tester via the CAN VIM.
  1. DTCs are output from each ECU in steering angle sensor communication stop mode as shown in the "DTC COMBINATION TABLE" (Click here).
  1. Power source or inside the steering angle sensor
  1. Steering angle sensor sub bus line or connector

WIRING DIAGRAM


B125028E02


INSPECTION PROCEDURE

1.CHECK CAN BUS LINE FOR DISCONNECTION (STEERING ANGLE SENSOR SUB BUS LINE)


    G030155E23
  1. Turn the ignition switch to the LOCK position.

  1. Disconnect the steering angle sensor connector (S9).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    S9-10 (CANH) - S9-9 (CANL)
    1. Ignition switch OFF
    2. Stop light switch OFF
    54 to 69 Ω



NG
REPAIR OR REPLACE STEERING ANGLE SENSOR SUB BUS LINE OR CONNECTOR (CAN-H, CAN-L)
OK


2.CHECK WIRE HARNESS (IG1, ESS)


    G030155E24
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    S9-2 (ESS) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Value
    S9-1 (IG) - Body ground
    1. Ignition switch ON
    2. Stop light switch OFF
    10 to 14 V



NG
REPAIR OR REPLACE WIRE HARNESS OR CONNECTOR
OK

REPLACE STEERING ANGLE SENSOR