Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > CAN Bus Line

for Preparation Click here


DESCRIPTION

When any DTC of the CAN communication system is output, first measure the resistance between the terminals of the DLC3 and the yaw rate sensor connector to specify the trouble area.

WIRING DIAGRAM


B125029E02


INSPECTION PROCEDURE

1.CHECK CAN BUS LINE (MAIN BUS LINE FOR DISCONNECTION, BUS LINES FOR SHORT CIRCUIT)


    G026206E57
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    Result
    D4-6 (CANH) -D4-14 (CANL)
    1. Ignition switch OFF
    2. Stop light switch OFF
    54 to 69 Ω
    OK
    D4-6 (CANH) - D4-14 (CANL)
    1. Ignition switch OFF
    2. Stop light switch OFF
    69 Ω or higher
    NG-A
    D4-6 (CANH) - D4-14 (CANL)
    1. Ignition switch OFF
    2. Stop light switch OFF
    Below 54 Ω
    NG-B



NG-A
CHECK CAN MAIN BUS LINE (FOR DISCONNECTION)

NG-B
CHECK CAN BUS LINE (FOR SHORT CIRCUIT)
OK


2.CHECK CAN BUS LINE (FOR SHORT TO +B)


    G026206E58
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    D4-6 (CANH) - D4-16 (BAT)
    1. Ignition switch OFF
    2. Stop light switch OFF
    1 MΩ or higher
    D4-14 (CANL) - D4-16 (BAT)
    1. Ignition switch OFF
    2. Stop light switch OFF
    1 MΩ or higher



NG
CHECK CAN BUS LINE (FOR SHORT TO +B)
OK


3.CHECK CAN BUS LINE (FOR SHORT TO GND)


    G026206E59
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    D4-4 (CG) - D4-6 (CANH)
    1. Ignition switch OFF
    2. Stop light switch OFF
    3 kΩ or higher
    D4-4 (CG) - D4-14 (CANL)
    1. Ignition switch OFF
    2. Stop light switch OFF
    3 kΩ or higher



NG
CHECK CAN BUS LINE (FOR SHORT TO GND)
OK

GO TO HOW TO PROCEED WITH TROUBLESHOOTING