Home › ENGINE · 1GR-FE › FUEL › FUEL INJECTOR

FUEL INJECTOR > INSPECTION

for Preparation Click here



1. INSPECT FUEL INJECTOR ASSEMBLY


A095332E03
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard:
      Tester Connection
      Specified Condition
      1 -2
      11.6 to 12.4 Ωat 20°C (68°F)

      If the result is not as specified, replace the fuel injector.



    A075912E01
  1. Check the injection volume.

    NOTICE:
    1. Perform the test in a well-ventilated area and watch out for flames.
    2. Handle the fuel tube connector carefully.


    1. Prepare a new fuel tube.

      HINT:
      Part No. 23801-0P010



    2. A062159E01
    3. Using a cutter knife, cut the fuel tube protector. Tear the protector by hand, then remove the fuel tube connector.

      NOTICE:
      If the protector is cut too deeply with the cutter, the O-ring of the fuel tube connector will be damaged.



    4. B012947E04
    5. Install the fuel tube connector into SST (hose), then connect the tube connector to the fuel pipe.

      SST
      09268-41047   (95336-08070)

      CAUTION:
      Connect the fuel tube connector (quick type) after observing the precautions.

    6. Remove the pressure regulator (Click here).

    7. Install the O-ring onto the fuel inlet of the pressure regulator.



    8. A076630E01
    9. Connect SST (hose) to the fuel inlet of the pressure regulator with another SST (union) and the 2 bolts.

      SST
      09268-41047   (95336-08070, 09268-41091)

      Torque:
      9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    10. Connect the fuel return hose to the fuel outlet of the pressure regulator.



    11. A075914E03
    12. Install a new O-ring onto the injector.

    13. Connect SST (adaptor and hose) to the injector and hold the injector and union with SST (clamp).

      SST
      09268-41047   (95336-08070)
      09268-41140  
      09268-41400  

    14. Set the injector in a graduated cylinder.

      CAUTION:
      Install a suitable vinyl tube onto the injector to prevent gasoline splashes.



    15. G035612E02
    16. Connect the intelligent tester to the DLC3.

    17. Turn the ignition switch to ON.

    18. Turn the intelligent tester ON.

    19. Select the following menu items: DIAGNOSIS / ENHANCED OBD ll / ACTIVE TEST / FUEL PUMP / SPD / ON.

    20. Install SST onto the fuel injector.

      SST
      09842-30080  



    21. A075915E06
    22. Connect SST to the battery, then measure the injection volume for 15 seconds. Perform the inspection 2 or 3 times, then calculate the average.

      Standard::
      Injection Volume
      Difference Between Each Fuel Injector
      76 to 91 cm3 (4.6 to 5.5 cu in.) per 15 seconds
      15 cm3 (0.9 cu in.) or less

      NOTICE:
      Always do the switching at the battery side.

      If the result is not as specified, replace the fuel injector.

  1. Check the fuel leakage.

    1. When checking the injection volume, remove SST from the battery. Inspect the fuel leakage from the fuel injector.

      Standard:
      1 drop or less every 12 minutes.

      If the result is not as specified, replace the fuel injector.