Home › ENGINE · 2TR-FE › FUEL › FUEL INJECTOR

FUEL INJECTOR > INSPECTION

for Preparation Click here



1. INSPECT FUEL INJECTOR ASSEMBLY


G037919E01
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Resistance:
      11.6 to 12.4 Ω at 20°C (68°F)

      If the result is not as specified, replace the fuel injector.



  1. Check the injection volume.

    CAUTION:
    This test involves high-pressure fuel and electricity, therefore, safety precautions should be taken. Perform this test in a safe area and avoid any sparks and flames. Do not smoke.


    1. Discharge the fuel system pressure (Click here).

    2. Remove the fuel hose from the fuel pressure pulsation damper .

    3. Remove the fuel hose from the fuel pipe (Click here).

    4. Separate the pressure regulator .

      NOTICE:
      Do not separate the fuel hose No.2.



    5. G037920E01
    6. Assemble SST as shown in the illustration.

      SST
      09268-41048   (09268-41091, 09268-41110, 09268-41120, 09268-41500, 95336-08070, 90467-13001)



    7. G037921E01
    8. Connect SST to the fuel pipe.

      SST
      09268-41048   (09268-41500, 90467-13001)



    9. G037922E03
    10. Install the pressure regulator onto SST (union) with the 2 bolts.

      Torque:
      8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

      SST
      09268-41048   (09268-41091)

      NOTICE:
      Make sure that the O-ring is installed onto the pressure regulator.



    11. G037923E01
    12. Install the O-ring onto the injector.

    13. Assemble SST as shown in the illustration.

      SST
      09268-41048   (09268-41110, 09268-41310)

    14. Put the injector into a graduated cylinder.

      CAUTION:
      Install a suitable vinyl tube onto the injector to contain any gasoline spray.



    15. G037924E01
    16. Make sure that SST is installed as shown in the illustration.

    17. Operate the fuel pump .



    18. G037830E01
    19. Connect SST (wire) to the injector and the battery for 15 seconds, and measure the injection volume with a graduated cylinder. Test each injector 2 or 3 times.

      SST
      09842-30080  

      Volume:
      71 to 86 cm3 (4.3 to 5.2 cu in.) per 15 seconds
      Difference between each

      injector:
      15 cm3 (0.9 cu in.) or less

      If the injection volume is not as specified, replace the injector.



    A087750E01
  1. Check the leakage.

    1. In the condition above, disconnect the tester probes of SST (wire) from the battery and check the fuel leakage from the injector.

      Fuel drop:
      1 drop or less in 12 minutes