AIRBAG SYSTEM > DIAGNOSIS SYSTEM |
| CHECK DLC3 |
![]() |
The vehicle's ECU uses the ISO 9141-2 for communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format.
| Symbols (Terminals No.) | Terminal Description | Condition | Specified condition |
| SIL (7) - SG (5) | Bus + line | During transmission | Pulse generation |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery positive | Always | 10 to 14 V |
| SYMPTOM SIMULATION |
![]() |
Vibration method: When vibration seems to be the major cause.
Slightly vibrate the part of the sensor considered to be the problem cause with your fingers and check whether the malfunction occurs.
Slightly shake the connector vertically and horizontally.
Slightly shake the wire harness vertically and horizontally.
The connector joint and fulcrum of the vibration are the major areas to be checked thoroughly.
| FUNCTION OF SRS WARNING LIGHT |
Primary check.
Turn the engine switch off. Wait for at least 2 seconds, then turn the engine switch on (IG). The SRS warning light comes on for approximately 6 seconds and the diagnosis of the airbag system (including the seat belt pretensioners) is performed.
Constant check.
After the primary check, the center airbag sensor assembly constantly monitors the airbag system for trouble.
Review.
When the airbag system is normal:
The SRS warning light comes on only during the primary check period (for approximately 6 seconds after the engine switch is turned on (IG)).
When the airbag system has trouble:
| SRS WARNING LIGHT CHECK |
![]() |
Turn the engine switch on (IG), and check that the SRS warning light comes on for approximately 6 seconds (primary check).
Check that the SRS warning light goes off approximately 6 seconds after the engine switch is turned on (IG) (constant check).
| PASSENGER AIRBAG ON/OFF INDICATOR CHECK |
![]() |
Turn the ignition switch to the ON position.
Check that the passenger airbag ON/OFF indicator (ON and OFF) comes on for approximately 4 seconds, then turns off for approximately 2 seconds.
| RELEASE METHOD OF ACTIVATION PREVENTION MECHANISM |
The activation prevention mechanism is built into the connector for the squib circuit of the SRS. As explained in the troubleshooting section, insert a piece of paper that is the same thickness as the male terminal between the terminal and the short spring to release it (refer to the illustrations on the next 3 pages).

