POWER WINDOW CONTROL SYSTEM > Power Window can be Operated After Ignition Switch is Turned OFF Even if Operative Conditions are not Met |

| 1.CHECK OPERATION FUNCTION AFTER IGNITION SWITCH IS TURNED OFF |
After the ignition switch is turned OFF:
Either front door is opened within 43 seconds but the power window can still operate. Proceed to A.
43 seconds pass and the power window can still operate. Proceed to B.
|
| ||||
| A | |
| 2.INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY |
![]() |
Remove the front door courtesy light switch.
Measure the switch resistance.
| Tester Connection | Condition | Specified Condition |
| 1 - Switch body | Switch pushed | 10 kΩ or higher |
| 1 - Switch body | Switch not pushed | Below 1 Ω |
Reinstall the front door courtesy light switch.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (FRONT DOOR COURTESY LIGHT SWITCH - DRIVER SIDE J/B (ECU)) |
![]() |
Disconnect the D11 and D12 front door courtesy light switch connector.
Disconnect the 1F and 1I driver side J/B connector.
Measure the resistance.
| Tester Connection | Specified Condition |
| D11-1 - DCTY (1F-7) | Below 1 Ω |
| D12-1 - PCTY (1I-8) | Below 1 Ω |
Reconnect the front door courtesy light switch connector.
Reconnect the driver side J/B connector.
|
| ||||
| OK | ||
| ||