Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

ANTI-LOCK BRAKE SYSTEM > TERMINALS OF ECU

for Preparation Click here



Terminals of ECU

C110610E02


Symbols (Terminals No.)
Terminal Description
GND1 (1)
Skid control ECU ground
+BS (2)
Solenoid valve power supply
GL1 (4) (*1) (*3)
Deceleration sensor signal input
P (6) (*2)
Shift position indicator P signal input
EXI2 (7) (*3)
Rear differential lock detection switch input
GGND (8) (*1) (*3)
Deceleration sensor ground
FL- (9)
Front LH wheel speed signal input
FL+ (10)
Front LH wheel speed sensor power supply
D/G (13)
Diagnosis tester communication line
STP (14)
Stop light switch input
RL+ (15)
Rear LH wheel speed sensor power supply
RL- (16)
Rear LH wheel speed signal input
WA (17)
ABS warning light output
SP1 (18) (*2)
Speed signal output for meter
TS (20)
Sensor diagnosis check input
TC (21)
Diagnosis tester communication line
PKB (23)
Parking brake switch input
EXI (24) (*3)
ADD change over actuator switch input
+BM (31)
Motor relay power supply
GND2 (32)
Skid control ECU ground
N (36) (*2)
Shift position indicator N signal input
VGS (37) (*1) (*3)
Deceleration sensor power supply
EXI4 (38) (*3)
Detection (L4) switch input
FR- (39)
Front RH wheel speed signal input
FR+ (40)
Front RH wheel speed sensor power supply
BRL (43)
Brake warning light input
RR+ (44)
Rear RH wheel speed sensor power supply
RR- (45)
Rear RH wheel speed signal input
IG1 (46)
ECU power supply

HINT:
(*1): Pre-runner
(*2): A/T
(*3): 4WD


Terminal Inspection
Disconnect the connector and measure the voltage on the wire harness side.

HINT:
Voltage cannot be measured with the connector connected to the skid control ECU as the connector is water resistant.


C124738E01


Symbols (Terminals No.)
Wiring Color
Terminal Description
Condition
STD Voltage (V)
+BS (2) - GND1 (1)
Y - W-B
Solenoid valve power supply
Always
10 to 14 V
STP (14) - GND1 (1)
L - W-B
Stop light switch input
Stop light switch ON
10 to 14 V
WA (17) - GND1 (1)
O - W-B
ABS warning light output
IG switch ON, ABS warning light ON
4 V or higher
PKB (23) - GND1 (1)
G-Y - W-B
Parking brake switch input
IG switch ON, parking brake switch ON
Below 2.0 V
PKB (23) - GND1 (1)
G-Y - W-B
Parking brake switch input
IG switch ON, parking brake switch OFF
8 to 14 V
+BM (31) - GND2 (32)
R - W-B
Motor relay power supply
Always
10 to 14 V
BRL (43) - GND1 (1)
B-W - W-B
Brake warning light output
IG switch ON, brake warning light ON
4 V or higher
IG (46) - GND1 (1)
LG - W-B
ECU power supply
IG switch ON
10 to 14 V