Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

ANTI-LOCK BRAKE SYSTEM > ABS Warning Light Remains ON

for Preparation Click here


DESCRIPTION

If any of the following is detected, the ABS warning light remains ON.
  1. The skid control ECU connectors are disconnected from the skid control ECU.
  2. There is a malfunction in the skid control ECU internal circuit.
  3. There is an open in the harness between the combination meter and skid control ECU.

HINT:
  1. When reading DTCs by SST (CHECK WIRE), if the ABS warning light remains on, troubleshoot by following the inspection flow.
  2. The intelligent tester may not be usable when there is a malfunction in the skid control ECU.


WIRING DIAGRAM


C124747E01


INSPECTION PROCEDURE

1.CHECK DTC
  1. Check if DTCs for ABS are recorded.

    Result
    Proceed to
    Normal system code output
    A
    DTC output
    B
    Other than above
    C



B
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS

C
Go to step 4
A


2.CHECK REAR DIFFERENTIAL LOCK SWITCH CONDITION

HINT:
Only for vehicles with rear differential locks.

  1. Check the rear diff. lock switch condition.

    Result
    Proceed to
    Rear diff. lock switch OFF
    A
    Rear diff. lock switch ON
    B



NG
SWITCH REAR DIFFERENTIAL LOCK SWITCH TO OFF (AFTER THIS FOLLOW TO STEP 3)
OK


3.CHECK ABS WARNING LIGHT


    C121700E09
  1. Disconnect the skid control ECU connector.

  1. Turn the ignition switch to the ON position.

  1. Ground terminal WA of the skid control ECU.

  1. Check ABS warning light.

    OK:
    WA - GND Condition
    Illumination Condition
    Connecting
    OFF
    Disconnecting
    ON

  1. Turn the ignition switch to OFF.

  1. Reconnect the skid control ECU connector.



NG
REPAIR COMBINATION METER SYSTEM
OK

REPLACE BRAKE ACTUATOR 

4.INSPECT SKID CONTROL ECU (IG1 TERMINAL VOLTAGE)
  1. When using intelligent tester:

    1. Connect the intelligent tester to the DLC3.

    2. Start the engine.

    3. Turn the intelligent tester ON.

    4. Select the DATA LIST mode on the intelligent tester.

    5. Measure the voltage output from the ECU displayed on the intelligent tester.


Item
Measurement Item / Range (Display)
Normal Condition
Diagnostic Note
IG VOLTAGE
ECU power supply voltage / TOO LOW / NORMAL / TOO HIGH
TOO HIGH: 14 V or more
NORMAL: 9.5 to 14V
TOO LOW: Below 9.5 V
-

OK:
"Normal" is displayed.



  1. When not using intelligent tester:



      F051654E07
    1. Disconnect the skid control ECU connector.

    2. Turn the ignition switch to the ON position.

    3. Measure the voltage.

      Standard Voltage:
      Tester Connection
      Specified Condition
      A9-46 (IG1) - Body ground
      11 to 14 V

    4. Turn the ignition switch to OFF.

    5. Reconnect the skid control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BRAKE ACTUATOR