OCCUPANT CLASSIFICATION SYSTEM (for Bench Seat Type) > INITIALIZATION |

| ZERO POINT CALIBRATION |
Zero point calibration procedures
Check that all of the following conditions are met:
Adjust the seat position according to the table below.
| Adjustment Item | Position |
| Slide Direction | Rearmost position |
| Reclining Angle | Upright position |
| Headrest Height | Lowest position |
| Lifter Height | Lowest position |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Perform the zero point calibration by following the prompts on the tester screen.

| Item | Procedure |
| DTC | Perform DTC check and repair |
| Write error | Replace front seat cushion assembly (with occupant classification ECU and occupant classification sensor) |
| Temperature | Check value of THERMISTOR TEMP in ECU DATA LIST |
| Pressure | Check value of FILTERED PRESS in ECU DATA LIST |
| Crash counter | - |
| SENSITIVITY CHECK |
Sensitivity check procedures
Turn the ignition switch to the LOCK position.
Turn the airbag cut-off switch to the AUTO position.
![]() |
Place a weight of 20 kg (44.0 lb) on the front passenger seat.
Turn the ignition switch to the ON position, and wait for at least 6 seconds.
Check that the passenger airbag ON/OFF indicator indicates OFF.
Add a weight of 30kg (66.1 lb) to the front passenger seat (total 50 kg (110.2 lb)).
Check that the passenger airbag ON/OFF indicator indicates ON.