Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > Clutch Switch Circuit

for Preparation Click here


DESCRIPTION

Clutch switch circuit inspection is necessary for M/T vehicles.
When the clutch pedal is released, the ECM receives the positive (+) battery voltage through the IG1 No.2 fuse and ignition switch. While the clutch pedal is depressed, the clutch switch assembly sends a signal to terminal D of the ECM. The ECM cancels cruise control when terminal D receives the signal (voltage of below 1 V).

WIRING DIAGRAM


B125025E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (ECM - BATTERY)


    I101322E02
  1. Turn the ignition switch OFF.

  1. Disconnect the E7 ECM connector.

  1. Turn the ignition switch to the ON position.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester connection
    Clutch Pedal condition
    Specification
    D(E7-21) - Body ground
    Depressed
    Below 1 V
    D(E7-21) - Body ground
    Released
    10 to 14 V

  1. Reconnect the ECM connector.



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.INSPECT CLUTCH SWITCH ASSEMBLY


    I031382E03
  1. Turn the ignition switch off.

  1. Disconnect the clutch switch C14 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester connection
    Clutch Pedal condition
    Specification
    C14-1 - C14-2
    Switch pin free
    (Clutch pedal depressed)
    10 kΩ or higher
    C14-1 - C14-2
    Switch pin pushed in
    (Clutch pedal released)
    Below 1 Ω

  1. Reconnect the clutch switch connector.



NG
REPLACE CLUTCH SWITCH ASSEMBLY
OK


3.CHECK HARNESS AND CONNECTOR (CLUTCH SWITCH ASSEMBLY - BODY GROUND)


    I101323E01
  1. Disconnect the E7 ECM connector.

  1. Disconnect the C14 clutch switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester connection
    Clutch Pedal condition
    Specification
    C14-2 - Body ground
    Always
    10 kΩ or higher
    C14-2 - D (E7-21)
    Always
    Below 1 Ω

  1. Reconnect the clutch switch connector.

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (CLUTCH SWITCH ASSEMBLY - ECM)
OK

CHECK AND REPAIR HARNESS OR CONNECTOR (CLUTCH SWITCH ASSEMBLY - BATTERY)