FRONT SEAT ASSEMBLY (for Separate Seat Type Driver Side) > DISASSEMBLY |
| 1. REMOVE FRONT SEAT HEADREST ASSEMBLY |
![]() |
Disengage the lock button of the front seat headrest support and remove the front seat headrest.
| 2. REMOVE LUMBAR ADJUSTER DIAL |
![]() |
Pull the lumbar adjuster dial outward.
| 3. REMOVE RECLINING ADJUSTER RELEASE HANDLE |
![]() |
Using a screwdriver with its tip taped in protective tape, disengage the claw and remove the reclining adjuster release handle.
| 4. REMOVE FRONT SEAT CUSHION SHIELD LH |
![]() |
Remove the screw.
Disengage the 2 claws and clip, and remove the front seat cushion shield.
| 5. REMOVE FRONT SEAT INNER BELT ASSEMBLY |
![]() |
Using a clip remover, remove the wire harness clamp and 2 connector clamps.
Remove the wire harness clamp.
Disconnect the seat position airbag sensor connector.
Remove the nut and front seat inner belt.
| 6. REMOVE FRONT SEAT CUSHION INNER SHIELD |
![]() |
Remove the screw.
Disengage the claw and clip, and remove the front seat cushion inner shield.
| 7. REMOVE FRONT SEAT HEADREST SUPPORT |
![]() |
w/ Front Seat Side Airbag:
Using a clip remover, remove the connector clamp.
Remove the wire harness clamp.
Remove the 5 hog rings.
![]() |
Disengage the 2 claws and remove the front seat headrest support.
| 8. REMOVE FRONT SEAT BACK COVER |
![]() |
Remove the 2 hog rings.
Remove the 2 wires.
![]() |
w/ Front Seat Side Airbag:
Remove the nut and strap.
Remove the 2 hog rings and front seat back cover.
Remove the front seat back pad from the front seat frame adjuster.
| 9. REMOVE FRONT SEAT CUSHION COVER |
![]() |
Remove the front seat cushion cover from the front seat frame adjuster.
Remove the 2 hog rings.
Disengage the 2 claws and 3 hooks, and remove the front seat cushion pad together with the front seat cushion cover.
![]() |
Remove the 10 hog rings and front seat cushion cover.
| 10. REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY |
![]() |
Remove the 2 wiring harness clamps.
Remove the 2 screws.
Disengage the 10 hooks and lumbar support adjuster.
| 11. REMOVE RECLINING ADJUSTER INSIDE COVER LH |
![]() |
Remove the screw.
Disengage the claw and remove the reclining adjuster inside cover.
| 12. REMOVE RECLINING ADJUSTER INSIDE COVER RH |
| 13. REMOVE RECLINING ADJUSTER OUTSIDE COVER LH |
![]() |
Remove the screw and reclining adjuster outside cover.
| 14. REMOVE RECLINING ADJUSTER OUTSIDE COVER RH |
| 15. REMOVE SEAT POSITION SENSOR |
![]() |
Using a "Torx" socket wrench T30, remove the screw and seat position sensor.