Home › BODY › SEAT › FRONT SEAT ASSEMBLY (for Bench Seat Type)

FRONT SEAT ASSEMBLY (for Bench Seat Type) > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SEAT ASSEMBLY


    B121741
  1. Place the front seat in the cabin.

  1. Slide the front seat to the most rearward position.

  1. Tighten the 2 bolts on the front side.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }

  1. Slide the front seat to the most forward position.

  1. Tighten the 2 bolts on the rear side.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }



    B121740
  1. Install the 2 wiring harness clamps.

  1. Connect the 3 connectors.



    B121739
  1. Install the belt of the front center seat outer belt into the front center seat outer belt guide.



2. INSTALL FRONT SEAT HEADREST ASSEMBLY


    B121738E01
  1. Push in the 2 lock buttons of the 2 front seat headrest supports and install the 2 front seat headrests.



3. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH


    B121779E01
  1. Slide the front seat to the most forward position.

  1. Install the front seat inner belt with the bolt.

    Torque:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Be careful not to place the front seat inner belt over the convex areas of the floor panel.

  1. Install the 2 wiring harness clamps.

  1. Connect the 2 connectors.

  1. Engage the hook.



4. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH


    B121780E01
  1. Slide the front seat to the most forward position.

  1. Install the front seat inner belt with the bolt.

    Torque:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Be careful not to place the front seat inner belt over the convex areas of the floor panel.

  1. Install the 2 wiring harness clamps.

  1. Connect the connector.

  1. Engage the hook.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }