REAR SEAT OUTER BELT ASSEMBLY (for Access Cab) > INSTALLATION |
| 1. INSTALL TETHER ANCHOR BRACKET SUB-ASSEMBLY |
![]() |
Hook the claw of the tether anchor bracket into the body hole.
Tighten bolt A, and then tighten bolt B.
| 2. INSTALL REAR SEAT OUTER BELT ASSEMBLY |
![]() |
Check the amount of inclination required to lock the retractor.
Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15° or less in any directions. Also check the belt locks when the inclination of the retractor is 45° or more.
![]() |
Hook the lower stay of the retractor onto the 2 body hooks.
Tighten the bolt.
![]() |
Install the shoulder anchor with the bolt.
Check that the shoulder anchor rotates smoothly.
![]() |
Install the floor anchor with the bolt.
Check the ELR lock.
With the belt installed, check that the belt locks when it is pulled out quickly.
If operation is not as specified, replace the rear seat outer belt.
Remove the bolt and floor anchor.
| 3. INSTALL QUARTER INSIDE TRIM BOARD |
![]() |
Engage the 3 clips and install the quarter inside trim board.
Tighten the screw.
![]() |
Engage the claw and close the cover.
| 4. INSTALL ROOF SIDE INNER GARNISH |
![]() |
Engage the 2 claws and clip, and install the roof side inner garnish.
| 5. INSTALL QUARTER TRIM LOWER PANEL |
![]() |
Engage the claw and 2 clips, and install the quarter trim lower panel.
![]() |
Install the floor anchor of the rear seat belt outer with the bolt.
| 6. INSTALL REAR SEAT INNER BELT ASSEMBLY |
![]() |
Engage the claw and install the buckle of the rear seat belt inner.
| 7. INSTALL BACK PANEL TRIM |
![]() |
Engage the 8 claws and 14 clips, and install the back panel trim.
| 8. INSTALL BACK PANEL TRIM COVER |
![]() |
Engage the 6 claws and install the back panel trim cover.
| 9. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP |
![]() |
Install the front door opening trim weatherstrip.
| 10. INSTALL ROOF SIDE INNER GARNISH CAP |
![]() |
Engage the 4 claws and install the roof side inner garnish cap.
Using a "Torx" socket wrench T30, tighten the 2 screws.
| 11. INSTALL ROOF SIDE INNER GARNISH COVER |
![]() |
Engage the 2 claws and install the roof side inner garnish cover.
| 12. INSTALL REAR DOOR SCUFF PLATE |
![]() |
Engage the 7 claws and install the rear door scuff plate.
| 13. INSTALL FRONT DOOR SCUFF PLATE |
![]() |
Engage the 9 claws and clip, and install the front door scuff plate.