REAR SEAT OUTER BELT ASSEMBLY (for Access Cab) > REMOVAL |
| 1. REMOVE FRONT DOOR SCUFF PLATE |
![]() |
Disengage the 9 claws and clip, and remove the front door scuff plate.
| 2. REMOVE REAR DOOR SCUFF PLATE |
![]() |
Disengage the 7 claws and remove the rear door scuff plate.
| 3. REMOVE ROOF SIDE INNER GARNISH COVER |
![]() |
Using a screwdriver with its tip taped in protective tape, disengage the 2 claws and remove the roof side inner garnish cover.
| 4. REMOVE ROOF SIDE INNER GARNISH CAP |
![]() |
Using a "Torx" socket wrench T30, remove the 2 screws.
Disengage the 4 claws and remove the roof side inner garnish cap.
| 5. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP |
![]() |
Separate the front door opening trim weatherstrip to the extent which allows the removal of the roof side garnish inner, quarter trim lower panel and quarter inside trim board.
| 6. REMOVE BACK PANEL TRIM COVER |
![]() |
Disengage the 6 claws and remove the back panel trim cover.
| 7. REMOVE REAR SEAT INNER BELT ASSEMBLY |
![]() |
Disengage the claw and remove the buckle of the rear seat belt inner.
| 8. REMOVE BACK PANEL TRIM |
![]() |
Disengage the 8 claws and 14 clips, and remove the back panel trim.
| 9. REMOVE QUARTER TRIM LOWER PANEL |
![]() |
Remove the bolt and floor anchor of the rear seat belt outer.
![]() |
Disengage the claw and 2 clips, and remove the quarter trim lower panel.
| 10. REMOVE ROOF SIDE INNER GARNISH |
![]() |
Disengage the 2 claws and clip, and remove the roof side inner garnish.
| 11. REMOVE QUARTER INSIDE TRIM BOARD |
![]() |
Using a screwdriver with its tip taped in protective tape, disengage the claw and open the cover.
![]() |
Remove the screw.
Disengage the 3 clips and remove the quarter inside trim board.
| 12. REMOVE REAR SEAT OUTER BELT ASSEMBLY |
![]() |
Remove the bolt and shoulder anchor.
![]() |
Remove the bolt and retractor.
| 13. REMOVE TETHER ANCHOR BRACKET SUB-ASSEMBLY |
![]() |
Remove the 2 bolts and tether anchor bracket.