Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > AMP Mute Signal Circuit (from Radio Receiver Assembly)

for Preparation Click here


DESCRIPTION

This circuit sends a signal to the stereo component amplifier to mute the noise. Because of that, the noise produced while changing the sound source ceases.
If there is an open in the circuit, noise can be heard from the speaker when changing the sound source.
If there is a short in the circuit, even though the stereo component amplifier assembly is normal, no sound or only extremely quiet sound is produced.

WIRING DIAGRAM


I045106E01


INSPECTION PROCEDURE

1.INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY


    I045104E01
  1. Measure the voltage.

    Standard:
    Tester Connection
    Condition
    Specified Condition
    MUTE (S23-1) - Body ground
    Turn ignition switch to ACC, Audio system is playing → Changing
    Above 3.5 V → Below 1 V



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO COMPONENT AMPLIFIER)


    I101944E02
  1. Disconnect the R1 radio receiver assembly connector and S23 stereo component amplifier assembly connector.

  1. Check the resistance.

    Standard:
    Tester Connection
    Condition
    Specified Condition
    MUTE (R1-7) - MUTE (S23-1)
    Always
    Below 1Ω
    MUTE (R1-7) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT RADIO RECEIVER ASSEMBLY


    I045113E01
  1. Reconnect the R1 stereo component amplifier assembly connector.

  1. Turn the ignition switch to the ACC position.

  1. Measure the voltage.

    Standard:
    Tester Connection
    Condition
    Specified Condition
    MUTE (R1-7) - Body ground
    Turn ignition switch to ACC
    3.5 V or higher



NG
REPAIR OR REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY
OK

REPLACE RADIO RECEIVER ASSEMBLY