Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > AVC-LAN Circuit

for Preparation Click here


DESCRIPTION

All audio system units that are connected to the AVC-LAN (communication bus) use it as the communication line by which they transmit switch signals.
When a +B short or GND short occurs in the AVC- LAN, the audio system fails to function normally, due to the discontinuation of communication.
In the AVC-LAN, the radio receiver assembly is the main communication center and has the correct resistance necessary for transmitting communication signals.

WIRING DIAGRAM


E120425E01


INSPECTION PROCEDURE

1.INSPECT RADIO RECEIVER ASSEMBLY


    I042749E01
  1. Disconnect the R1 radio receiver assembly connector.

  1. Measure the resistance.

    Standard:
    Tester Connection
    Condition
    Specified Condition
    TX+ (R1-5) - TX (R1-15)
    Always
    60 to 80 Ω



NG
REPLACE RADIO RECEIVER ASSEMBLY
OK


2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO COMPONENT AMPLIFIER)


    I101944E04
  1. Disconnect the R1 radio receiver assembly connector and S23 stereo component amplifier assembly connector.

  1. Check the resistance.

    Standard:
    Tester Connection
    Specified Condition
    TX+ (S23-8) - TX+ (R1-15)
    Below 1 Ω
    TX+ (S23-7) - TX- (R1-15)
    Below 1 Ω
    TX+ (R1-5) - Body ground
    10 kΩ or higher
    TX+ (R1-5) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY


NG
REPLACE RADIO RECEIVER ASSEMBLY
OK

END