Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Malfunction in Water Temperature Warning Light

for Preparation Click here


WIRING DIAGRAM


B125018E01


INSPECTION PROCEDURE

HINT:
  1. Start the inspection from step 1 when using an intelligent tester and start from step 2 when not using an intelligent tester.
  2. If there is an open or short in the engine coolant temperature sensor circuit, the ECM outputs DTCs. Troubleshoot those DTCs by following the SFI System.
    2TR-FE: (Click here )
    1GR-FE: (Click here)

1.READ VALUE OF INTELLIGENT TESTER (ENGINE COOLANT TEMPERATURE)
  1. Connect an intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester ON.

  1. On the tester, select the following menu items: DIAGNOSIS / ENHANCED OBD II / DATA LIST / ALL / COOLANT TEMP.

  1. Read the value displayed on the tester.

    Standard:
    Between 80°C and 97°C (176°F and 207°F) with the engine warmed up.



NG
GO TO ENGINE CONTROL SYSTEM
OK


2.INSPECT COMBINATION METER ASSEMBLY


    I044513E07
  1. Disconnect the C9 combination meter connector.

  1. Measure the voltage.

    Standard Voltage:
    Tester Condition
    Condition
    Specified Condition
    C9-9 - Body ground
    Ignition switch ON, Coolant temperature is 90°C (194°F)
    10 to 14 V

  1. Reconnect the combination meter connector.



OK
REPLACE COMBINATION METER ASSEMBLY
NG


3.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM)


    I101310E03
  1. Disconnect the C9 combination meter connector.

  1. Disconnect the E7 ECM connector.

  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    C9-9 - E7-14
    Below 1 Ω
    C9-9 or E7-14 - Body ground
    10 kΩ or higher

  1. Reconnect the ECM connector.

  1. Reconnect the combination meter connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM