Home › ENGINE ยท 1GR-FE › FUEL › FUEL PRESSURE REGULATOR

FUEL PRESSURE REGULATOR > INSTALLATION

for Preparation Click here



1. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY
  1. Install the vacuum hose.

  1. Apply a light coat of spindle oil or gasoline to a new O-ring and install it onto the fuel pressure regulator.

  1. Install the fuel pressure regulator with the 2 bolts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }



2. CONNECT NO.2 FUEL PIPE SUB-ASSEMBLY
  1. Push the tube connector into the pipe until the tube connector makes a "click" sound.

    NOTICE:
    1. Check if there is any damage or foreign objects on the connected part of the fuel pipe.
    2. After connecting, check that the pipe and connector are securely connected by pulling them.

  1. Install the fuel pipe clamp.



3. INSTALL AIR CLEANER ASSEMBLY
  1. Install the air cleaner with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the ventilation hose No. 2.



4. INSTALL V-BANK COVER
  1. Install the V-bank cover with the 2 nuts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }



6. CHECK FOR FUEL LEAKAGE