FUEL PRESSURE REGULATOR > INSTALLATION |
| 1. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY |
![]() |
Apply a light coat of gasoline or spindle oil to the O-ring.
![]() |
Install the fuel pressure regulator with the 3 bolts.
![]() |
Install the harness clamp bracket with the bolt.
Connect the engine wire harness clamp.
Connect the VSV connector.
Connect the throttle with motor body connectors.
| 2. CONNECT NO. 2 FUEL HOSE |
![]() |
Align the fuel hose connector with the pipe stem, and insert the fuel hose until the retainer makes a "click" sound.
Push down the checker of the fuel hose.
Push the fuel hose down until the checker of the fuel hose makes a "click" sound.
| 3. INSTALL INTAKE AIR CONNECTOR |
![]() |
Install the intake air connector with the 3 bolts.
Tighten the 2 hose clamp bolts.
![]() |
Connect the vacuum hose.
![]() |
Connect the ventilation hose No. 2.
![]() |
Connect the vacuum hose.
Engage the wire harness clamp.
Connect the pressure sensor connector.
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. CHECK FOR FUEL LEAKAGE |
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester ON.
Select the following menu items: DIAGNOSIS / ENHANCED OBD II / ACTIVE TEST / FUEL PUMP / SPD / ON.
Check that there are no leakage in the fuel system.