Home › BODY › SEAT › REAR SEAT ASSEMBLY (for LH Side)

REAR SEAT ASSEMBLY (for LH Side) > REASSEMBLY

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp surface on the rear seat back frame could cause injuries to your hands.



1. INSTALL REAR SEAT BACK COVER


    B113815E02
  1. Using hog ring pliers, install the rear seat back cover with new hog rings.

    NOTICE:
    1. Do not contaminate or scratch the rear seat back cover.
    2. When installing the hog rings, minimize wrinkles as far as possible.



2. INSTALL REAR SEAT LOCK HANDLE


    B087208E01
  1. Install the rear seat lock handle onto the rear seat back lock.



3. INSTALL REAR SEAT BACK LOCK ASSEMBLY


    B087207E01
  1. Install the rear seat back lock with the 2 bolts.

    Torque:
    30 N*m{ 305 kgf*cm , 22 ft.*lbf }



4. INSTALL REAR SEAT BACK FRAME SUB-ASSEMBLY


    B113816E02
  1. Install the rear seat back spring into the rear seat back pad.

  1. Using hog ring pliers, install new hog rings.



5. INSTALL REAR SEAT HEADREST SUPPORT


B087205E01

HINT:
Follow the same procedures as for the opposite side.

  1. Engage the 2 claws and install the front seat headrest support.



6. INSTALL REAR SEAT BACK BOARD SUB-ASSEMBLY


    B087204E01
  1. Engage the 4 claws and install the rear seat back board.

  1. Tighten the 2 screws.



7. INSTALL REAR SEAT HEADREST ASSEMBLY


    B087203E02
  1. Disengage the lock button of the rear seat headrest support and install the rear seat headrest.



8. INSTALL REAR SEAT CUSHION COVER


    B113818E02
  1. Using hog ring pliers, install the rear seat cushion cover with new hog rings.

    NOTICE:
    1. Do not contaminate or scratch the rear seat cushion cover.
    2. When installing the hog rings, minimize wrinkles as far as possible.



9. INSTALL REAR SEAT CUSHION FRAME SUB-ASSEMBLY


    B087200E01
  1. Engage the hook and install the rear seat cushion frame.



10. INSTALL REAR SEAT CUSHION HINGE SUB-ASSEMBLY


B087210E01

HINT:
Follow the same procedures as for the opposite side.

  1. Install the rear seat cushion hinge with the bolts.

    Torque:
    21 N*m{ 215 kgf*cm , 16 ft.*lbf }



11. INSTALL REAR SEAT HEADREST HOLDER


B088236E01

HINT:
Follow the same procedures as for the opposite side.

  1. Engage the 2 claws and install the rear seat headrest holder.



12. INSTALL REAR SEAT CUSHION BAND


    B087198E01
  1. Install the rear seat cushion band with the screw.