Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › MAGNETIC CLUTCH RELAY

MAGNETIC CLUTCH RELAY > INSPECTION

for Preparation Click here



1. INSPECT MAGNET-CLUTCH RELAY


    I100429E01
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard:
      Tester Connection
      Specified Condition
      3 - 5
      10 kΩ or higher
      3 - 5
      Below 1 Ω
      (Apply battery voltage to terminals 1 and 2)

      If the result is not as specified, replace the relay.