CLUTCH SWITCH > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT FLOOR FOOTREST |
![]() |
Disengage the 2 clips and remove the front floor footrest.
| 3. REMOVE FRONT DOOR SCUFF PLATE LH (for Regular Cab) |
![]() |
Disengage the 8 claws and clip, and remove the front door scuff plate.
| 4. REMOVE FRONT DOOR SCUFF PLATE LH (for Access Cab) |
![]() |
Disengage the 9 claws and clip, and remove the front door scuff plate.
| 5. REMOVE FRONT DOOR SCUFF PLATE LH (for Double Cab) |
![]() |
Disengage the 9 claws and remove the front door scuff plate.
| 6. REMOVE COWL SIDE TRIM BOARD LH (for Regular Cab) |
![]() |
Remove the clip.
Disengage the 2 clips and remove the cowl side trim board.
| 7. REMOVE COWL SIDE TRIM BOARD LH (for Access Cab) |
![]() |
Remove the clip.
Disengage the 2 clips and remove the cowl side trim board.
| 8. REMOVE COWL SIDE TRIM BOARD LH (for Double Cab) |
![]() |
Remove the clip.
Disengage the 2 clips and remove the cowl side trim board.
| 9. REMOVE INSTRUMENT PANEL UNDER TRAY (for Pedal Type Parking Brake) |
![]() |
Disengage the 4 clips and 2 claws, and remove the instrument panel under tray.
| 10. REMOVE INSTRUMENT PANEL HOLE COVER (for Lever Type Parking Brake) |
![]() |
Disengage the 4 clips and remove the instrument panel hole cover.
| 11. SEPARATE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
![]() |
Disengage the 2 claws.
![]() |
Disconnect the hood lock control cable assembly and remove the hood lock control lever sub-assembly.
| 12. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL |
![]() |
Remove the 2 bolts <B>.
Disengage the 3 clips and remove the lower No. 1 instrument panel finish panel.
Disconnect the connectors.
| 13. SEPARATE DRIVER SIDE JUNCTION BLOCK |
![]() |
Remove the 2 bolts and bracket.
Remove the 2 nuts and separate the driver side junction block assembly.
| 14. REMOVE CLUTCH SWITCH ASSEMBLY |
![]() |
Disconnect the connector.
Loosen the nut and remove the clutch switch assembly.