AIR CONDITIONING UNIT > DISASSEMBLY |
| 1. REMOVE DEFROSTER NOZZLE ASSEMBLY LOWER |
![]() |
Remove the 4 bolts and the defroster nozzle assembly lower.
| 2. REMOVE HEATER TO REGISTER CENTER DUCT |
![]() |
Remove the 2 bolts and heater to register duct center.
| 3. REMOVE NO. 1 AIR DUCT |
![]() |
Remove the bolt.
Disengage the 3 claws and remove the air duct.
| 4. REMOVE AIR FILTER |
![]() |
Push down on the 2 tabs and open the filter door.
Remove the air filter.
| 5. REMOVE MODE CONTROL SERVO MOTOR |
![]() |
Remove the 3 bolts and mode control servo motor.
| 6. REMOVE AIR MIX CONTROL SERVO MOTOR |
![]() |
Remove the 2 bolts and air mix control servo motor.
| 7. REMOVE AIR INLET CONTROL SERVO MOTOR |
![]() |
Remove the 2 bolts and air inlet control servo motor.
| 8. REMOVE HEATER RADIATOR ASSEMBLY |
![]() |
Remove the 3 bolts and temperature mounting plate.
![]() |
Remove the temperature cam.
![]() |
Remove the 8 bolts and heater cover case.
![]() |
Using "Torx" socket wrench T30, remove the bolt, clamp and heater radiator assembly.
| 9. REMOVE BLOWER RESISTOR |
![]() |
Remove the 2 bolts and blower resistor.
| 10. REMOVE BLOWER MOTOR |
![]() |
Remove the 3 bolts and blower motor.
| 11. REMOVE EVAPORATOR CORE |
![]() |
Remove the 3 bolts and mode mounting plate.
![]() |
Remove the mode cam.
![]() |
Remove the bolt and heater pivot.
![]() |
Disengage the clip and remove the 11 bolts and mode case.
![]() |
Remove the evaporator core.
| 12. REMOVE VALVE TO CONNECTOR TUBE |
![]() |
Using "Torx" socket wrench E10, remove the bolt and valve to connector tube.
Remove the 2 seal washers from the air conditioning tube assembly.
| 13. REMOVE EXPANSION VALVE |
![]() |
Using "Torx" socket wrench T25, remove the 2 bolts and expansion valve.
Remove the 2 seal washers from the expansion valve.
| 14. REMOVE COOLER THERMISTOR SENSOR |
![]() |
Disengage the 2 clamps and remove the cooler thermistor sensor.
| 15. REMOVE NO. 1 COOLER UNIT DRAIN HOSE |