Home › BODY › EXTERIOR › FRONT DOOR BELT MOULDING

FRONT DOOR BELT MOULDING > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT DOOR FRAME BRACKET LOWER GARNISH
  1. w/ Power Window:

    1. Remove the front door frame bracket lower garnish .

  1. w/o Power Window:

    1. Remove the front door frame bracket lower garnish .



3. REMOVE FRONT DOOR ARMREST BASE UPPER PANEL SUB-ASSEMBLY (w/ Power Window)
  1. for Double Cab:

    1. Remove the front door armrest base upper panel sub-assembly .

  1. for Access Cab and Regular Cab:

    1. Remove the front door armrest base upper panel sub-assembly .



4. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


    B088112
  1. Pull out the snap ring with a cloth as shown in the illustration, then remove the door window regulator handle assembly.



    B088113
  1. Remove the window regulator handle plate.



5. REMOVE FRONT DOOR TRIM PANEL ASSEMBLY
  1. w/ Power Window:

    1. Remove the front door trim panel assembly .

  1. w/o Power Window:

    1. Remove the front door trim panel assembly .



6. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY


B087556E01
  1. Disconnect the outer rear view mirror connector (w/ Power mirror).

  1. Remove the 3 nuts.

  1. Disengage the claw and remove the outer rear view mirror.



7. REMOVE FRONT DOOR BELT MOULDING


    B088216E02
  1. Apply protective tape to the outer circumference of the front door belt moulding, as shown in the illustration.

  1. Using a moulding remover, disengage the 5 claws and remove the front door belt moulding.