DIFFERENTIAL SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT H2 (2WD)-H4 (4WD) SHIFT |
![]() |
Start the engine.
Turn the four wheel drive control switch from the H2 position to the H4 position.
Check that the 4WD indicator light blinks and then stays on.
Turn the four wheel drive control switch from the H4 position to the H2 position.
Check that the 4WD indicator light blinks and then goes off.
| 2. INSPECT H4 (4WD)-L4 (4WD) SHIFT |
![]() |
Start the engine.
Turn the four wheel drive control switch from the H4 position to the L4 position while pressing it.
Check that the 4LO indicator light blinks and then stays on.
Turn the four wheel drive control switch from the L4 position to the H4 position while pressing it.
Check that the 4LO indicator light blinks and then goes off.
| 3. INSPECT H2 (2WD)-L4 (4WD) SHIFT |
![]() |
Start the engine.
Turn the four wheel drive control switch from the H2 position to the H4 position.
Check that the 4WD indicator light blinks and then stays on.
Turn the four wheel drive control switch from the H4 position to the L4 position while pressing it.
Check that the 4LO indicator light blinks and then stays on.
| 4. INSPECT L4 (4WD)-H2 (2WD) SHIFT |
![]() |
Start the engine.
Turn the four wheel drive control switch from the L4 position to the H4 position while pressing it.
Check that the 4LO indicator light blinks and then goes off.
Turn the four wheel drive control switch from the H4 position to the H2 position.
Check that the 4WD indicator light blinks and then goes off.