Home › DRIVE LINE › DIFFERENTIAL › DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL (for 4WD)

DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL (for 4WD) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT WHEELS


3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Remove the 4 bolts and No. 1 engine under cover sub-assembly.



4. REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Engine Under Cover No, 2)
  1. Remove the 4 bolts and No. 2 engine under cover sub-assembly.



5. DRAIN DIFFERENTIAL OIL


6. REMOVE FRONT AXLE HUB LH NUT


F042729
  1. Using a screwdriver and a hammer, remove the front axle hub grease cap.



    F042732
  1. Remove the cotter pin and adjusting cap.

  1. Remove the front axle hub nut.



7. REMOVE FRONT AXLE HUB RH NUT

HINT:
Use the same procedure as for the LH side.



8. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH


G020161
  1. Remove the 2 nuts and front stabilizer link LH.

    HINT:
    If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.



9. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH

HINT:
The removal procedure for the RH side is the same as that for the LH side.



10. SEPARATE FRONT SPEED SENSOR LH


C114967E02
  1. Disconnect the speed sensor connector.

  1. Remove the bolt and front speed sensor.

    NOTICE:
    1. Do not attach any foreign matter to the sensor tip.
    2. Ensure that no foreign matter enters the sensor installation part.



11. SEPARATE FRONT SPEED SENSOR RH

HINT:
Use the same procedure as for the LH side.



12. SEPARATE TIE ROD END SUB-ASSEMBLY LH
  1. Remove the cotter pin and nut.



    F051679E02
  1. Using SST, separate the tie rod end from the steering knuckle arm.

    SST
    09628-62011  



13. SEPARATE TIE ROD END SUB-ASSEMBLY RH

HINT:
The removal procedure for the RH side is the same as that for the LH side.



14. REMOVE FRONT SUSPENSION LOWER ARM LH


G020159
  1. Remove the 2 bolts and separate the front lower ball joint attachment front from the steering knuckle.



15. REMOVE FRONT SUSPENSION LOWER ARM RH

HINT:
Use the same procedure as for the LH side.



16. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH


F042739E01
  1. Using SST, remove the front drive shaft.

    SST
    09520-01010  
    09520-24010   (09520-32040)

    NOTICE:
    Be careful not to damage the oil seal.



17. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



18. REMOVE DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL


    C097017E02
  1. Using SST, remove the oil seal.

    SST
    09308-00010