Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER WITH COIL SPRING (for 2WD)

FRONT SHOCK ABSORBER WITH COIL SPRING (for 2WD) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT WHEEL


3. SEPARATE SKID CONTROL SENSOR WIRE


F051488
  1. Remove the speed sensor connector.

  1. Remove the 2 bolts, and separate the skid control sensor wire.



4. SEPARATE FRONT FLEXIBLE HOSE


F051489
  1. Remove the bolt, and separate the front flexible hose.



5. REMOVE FRONT SUSPENSION UPPER ARM


F051490E01
  1. Support the front suspension lower arm with a jack.

  1. Remove the clip and nut.

  1. Using SST, separate the upper ball joint from the steering knuckle.

    SST
    09628-62011  



    F051491
  1. Remove the 2 bolts.

  1. Remove the front suspension upper arm.



6. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING


F051503
  1. Remove the bolt, nut and washer.



    F051504
  1. Remove the 3 nuts on the upper side of the front shock absorber with coil spring.

  1. Remove the front shock absorber with coil spring.