FRONT SHOCK ABSORBER WITH COIL SPRING (for 4WD and Pre-Runner) > INSTALLATION |
| 1. TEMPORARILY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING |
![]() |
Install the coil spring onto the body with the lower end of the coil spring facing the rear side of the vehicle.
![]() |
Install the 3 nuts onto the upper side of the front shock absorber with coil spring.
![]() |
Temporarily tighten the bolt, nut and washer as shown in the illustration.
| 2. INSTALL TIE ROD END SUB-ASSEMBLY |
Install the tie rod end onto the steering knuckle arm.
Install the nut.
Install a new cotter pin.
| 3. INSTALL FRONT STABILIZER BAR |
| 4. INSTALL FRONT STABILIZER BRACKET NO. 1 LH |
![]() |
Install the front stabilizer bracket with the 2 bolts.
| 5. INSTALL FRONT STABILIZER BRACKET NO. 1 RH |
| 6. INSTALL FRONT STABILIZER LINK ASSEMBLY LH |
![]() |
Connect the stabilizer link to the steering knuckle with the nut.
| 7. INSTALL FRONT STABILIZER LINK ASSEMBLY RH |
| 8. INSTALL ENGINE UNDER COVER SUB-ASSEMBLY NO. 1 |
| 9. INSTALL FRONT WHEELS |
| 10. STABILIZE SUSPENSION |
Jack down the vehicle.
Bounce the vehicle up and down several times to stabilize the suspension.
| 11. FULLY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING |
![]() |
Fully tighten the nut.
| 12. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |