Home › SUSPENSION & AXLE › SUSPENSION › FRONT UPPER SUSPENSION ARM (for 2WD)

FRONT UPPER SUSPENSION ARM (for 2WD) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT WHEEL


3. INSPECT FRONT SUSPENSION UPPER ARM
  1. Check that there is no slack on the ball joint by shaking the upper arm up and down by hand.



4. SEPARATE SKID CONTROL SENSOR WIRE


F051488
  1. Remove the speed sensor connector.

  1. Remove the 2 bolts, and separate the skid control sensor wire.



5. SEPARATE FRONT FLEXIBLE HOSE


F051489
  1. Remove the bolt, and separate the front flexible hose.



6. REMOVE FRONT SUSPENSION UPPER ARM


F051490E01
  1. Support the front suspension lower arm with a jack.

  1. Remove the clip and nut.

  1. Using SST, separate the upper ball joint from the steering knuckle.

    SST
    09628-62011  



    F051491
  1. Remove the 2 bolts.

  1. Remove the front suspension upper arm.