Home › SUSPENSION & AXLE › SUSPENSION › FRONT UPPER SUSPENSION ARM (for 4WD and Pre-Runner)

FRONT UPPER SUSPENSION ARM (for 4WD and Pre-Runner) > INSTALLATION

for Preparation Click here



1. TEMPORARILY TIGHTEN FRONT SUSPENSION UPPER ARM


G020153
  1. Install the front suspension upper arm, and temporarily tighten the bolt, 2 washers and nut.



    G020152
  1. Install the bracket with the bolt.

    Torque:
    5.8 N*m{ 59 kgf*cm , 51 in.*lbf }



    G020157
  1. Install a new nut and a new clip.

    Torque:
    110 N*m{ 1,122 kgf*cm , 81 ft.*lbf }



2. INSTALL SKID CONTROL SENSOR WIRE


C099168
  1. Install the skid control sensor wire with the 2 bolts.

    Torque:
    12.5 N*m{ 127 kgf*cm , 9 ft.*lbf }



3. INSTALL FRONT WHEEL

Torque:
113 N*m{ 1,152 kgf*cm , 83 ft.*lbf }



4. STABILIZE SUSPENSION
  1. Jack down the vehicle.

  1. Bounce the vehicle up and down several times to stabilize the suspension.



5. FULLY TIGHTEN FRONT SUSPENSION UPPER ARM


G020158
  1. Fully tighten the nut.

    Torque:
    115 N*m{ 1,173 kgf*cm , 85 ft.*lbf }



6. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(Click here)