Home › SUSPENSION & AXLE › SUSPENSION › FRONT STABILIZER BAR (for 2WD)

FRONT STABILIZER BAR (for 2WD) > INSTALLATION

for Preparation Click here



1. INSTALL FRONT STABILIZER BAR


2. INSTALL FRONT STABILIZER LOWER BRACKET BUSH LH


F051487E01
  1. Install the front stabilizer lower bracket bush.

    HINT:
    1. Install the bush onto the inner side of the bush stopper on the stabilizer bar.
    2. Install the bush onto the stabilizer bar with its cut line facing to the front.



3. INSTALL FRONT STABILIZER LOWER BRACKET BUSH RH

HINT:
The installation procedure for the RH side is the same as that for the LH side.



4. INSTALL FRONT STABILIZER BRACKET NO. 1 LH


F051486
  1. Install the front stabilizer bracket with the 2 bolts.

    Torque:
    21 N*m{ 214 kgf*cm , 16 ft.*lbf }



5. INSTALL FRONT STABILIZER BRACKET NO. 1 RH

HINT:
The installation procedure for the RH side is the same as that for the LH side.



6. INSTALL FRONT STABILIZER LINK ASSEMBLY LH


F051485E01
  1. Install the front stabilizer link LH with the 2 nuts, 2 cushions and 2 retainers.

    Torque:
    Nut A:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }
    Nut B:
    69 N*m{ 704 kgf*cm , 51 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.



7. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:
The installation procedure for the RH side is the same as that for the LH side.



8. INSTALL FRONT WHEELS

Torque:
113 N*m{ 1,152 kgf*cm , 83 ft.*lbf }