Home › SUSPENSION & AXLE › SUSPENSION › FRONT STABILIZER BAR (for 4WD and Pre-Runner)

FRONT STABILIZER BAR (for 4WD and Pre-Runner) > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEELS


2. REMOVE ENGINE UNDER COVER SUB-ASSEMBLY NO. 1


3. REMOVE FRONT STABILIZER LINK ASSEMBLY LH


G020161
  1. Remove the 2 nuts and front stabilizer link LH.

    HINT:
    If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.



4. REMOVE FRONT STABILIZER LINK ASSEMBLY RH

HINT:
The removal procedure for the RH side is the same as that for the LH side.



5. REMOVE FRONT STABILIZER BRACKET NO. 1 LH


G020162
  1. Remove the 2 bolts and front stabilizer bracket.



6. REMOVE FRONT STABILIZER BRACKET NO. 1 RH

HINT:
The removal procedure for the RH side is the same as that for the LH side.



7. REMOVE FRONT STABILIZER LOWER BRACKET BUSH LH


8. REMOVE FRONT STABILIZER LOWER BRACKET BUSH RH


9. REMOVE FRONT STABILIZER BAR