Home › DRIVE LINE › VF2BM TRANSFER › TRANSFER CASE OIL SEAL

TRANSFER CASE OIL SEAL > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for 1GR-FE)


2. DRAIN TRANSFER OIL


3. REMOVE EXHAUST FRONT PIPE ASSEMBLY NO. 2 (for 1GR-FE)
  1. Remove the 2 bolts and 2 nuts, then separate the exhaust front pipe No. 2 from the exhaust front pipe.

  1. Remove the 2 nuts, then separate the exhaust front pipe No. 2 from the exhaust manifold LH.

  1. Separate the insulator, then remove the exhaust front pipe No. 2.



4. REMOVE PROPELLER SHAFT HEAT INSULATOR BRACKET SUB-ASSEMBLY (for 1GR-FE)


F052217
  1. Remove the 2 bolts and propeller shaft heat insulator bracket.



5. REMOVE PROPELLER SHAFT ASSEMBLY FRONT


C098708E02
  1. Place matchmarks on the propeller shaft flange and differential flange.

  1. Remove the 4 nuts, 4 bolts, 4 washers and front propeller shaft.



    C098709E02
  1. Place matchmarks on the propeller shaft flange and transfer flange.

  1. Remove the 4 nuts, 4 washers and front propeller shaft.



6. REMOVE OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY


D029929E01
  1. Using a chisel and hammer, loosen the staked part of the output shaft companion flange lock nut.

  1. Using SST to hold the output shaft companion flange, remove the output shaft companion flange lock nut.

    SST
    09330-00021  



    D029930E01
  1. Using SST, remove the output shaft companion flange sub-assembly (front side).

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04030, 09954-04010, 09955-04051, 09957-04010, 09958-04011)



7. REMOVE TRANSFER CASE OIL SEAL


F043485E02
  1. Using SST, remove the oil seal.

    SST
    09308-00010  

    NOTICE:
    Do not damage the oil-seal-fitted surface of the case.