Home › DRIVE LINE › VF2BM TRANSFER › EXTENSION HOUSING OIL SEAL

EXTENSION HOUSING OIL SEAL > REMOVAL

for Preparation Click here



1. DRAIN TRANSFER OIL


2. REMOVE PROPELLER SHAFT ASSEMBLY (for Regular Cab)


C060588E01
  1. Place matchmarks on the propeller shaft flange and differential flange.

  1. Remove the 4 nuts, 4 bolts, 4 washers and front propeller shaft.



    C098709E02
  1. Place matchmarks on the propeller shaft flange and transfer flange.

  1. Remove the 4 nuts, 4 washers and front propeller shaft.



3. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for Except Regular Cab)


C060588E01
  1. Place matchmarks on the propeller shaft flange and differential flange.

  1. Remove the 4 nuts, 4 bolts and 4 washers, and remove the propeller shaft.



    D033912
  1. Remove the 2 center support bearing bolts from the frame crossmember.



    D033911E01
  1. Pull out the propeller shaft.

  1. Insert SST into the transmission to prevent oil leakage.

    SST
    09325-40010  



4. REMOVE OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
  1. Remove the rear output shaft companion flange sub-assembly using the same procedure as for the front output shaft companion flange sub-assembly (rear side).

    SST
    09330-00021  
    09950-40011   (09951-04020, 09952-04010, 09953-04030, 09954-04010, 09955-04051, 09957-04010, 09958-04011)



5. REMOVE TRANSFER EXTENSION HOUSING TYPE T OIL SEAL


F043484E02
  1. Using SST, remove the oil seal.

    SST
    09308-00010  

    NOTICE:
    Do not damage the oil-seal-fitted surface of the extension housing sub-assembly rear.