Home › TRANSMISSION ยท A340E AUTOMATIC TRANSMISSION › ATF TEMPERATURE SENSOR

ATF TEMPERATURE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL TEMPERATURE SENSOR
  1. Coat a new O-ring with ATF and install it onto the temperature sensor.

  1. Install the temperature sensor.

    Torque:
    29 N*m{ 300 kgf*cm , 22 ft.*lbf }

  1. Connect the temperature sensor connector.



2. CONNECT NO. 1 OIL COOLER INLET TUBE


F050804E01
  1. Using SST, tighten oil cooler inlet tube No. 1.

    SST
    09023-12701  

    Torque:
    34 N*m{ 350 kgf*cm , 25 ft.*lbf }



    F050803E01
  1. Install the 3 clamps and 3 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 8.9 ft.*lbf } for bolt A
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf } for bolt B



3. INSPECT AUTOMATIC TRANSMISSION FLUID

HINT:
Drive the vehicle until the engine and transmission are at normal operating temperature.

Fluid temperature:
70 to 80 °C (158 to 176 °F)



    F051843E01
  1. Park the vehicle on a level surface and engage the parking brake.

  1. With the engine idling and the brake pedal depressed, shift the shift lever into all positions from P to L, and then return it to the P position.

  1. Pull out the oil level gage and wipe it clean.

  1. Push it back fully into the pipe.

  1. Pull it out and check that the fluid level is within the HOT range.
    If there is any leakage, repair or replace O-rings, FIPGs, oil seals, plugs or other parts.