VALVE BODY ASSEMBLY > INSTALLATION |
| 1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY |
![]() |
Install the shift solenoid valve SLU with the bolt.
Install the shift solenoid valves S1 and S2 with the bolt.
Install the shift solenoid valve SLT with the bolt.
![]() |
Align the groove of the manual valve with the pin of the lever.
![]() |
Install the 20 bolts.
| 2. INSTALL TRANSMISSION WIRE |
![]() |
Coat a new O-ring with ATF, and install it onto the solenoid wiring.
Install the solenoid wiring onto the case, and install the stopper plate.
![]() |
Connect the connectors to each shift solenoid valve.
| 3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY |
![]() |
Install 5 new gaskets.
![]() |
Install the oil strainer with the 4 bolts.
| 4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY |
![]() |
Install the 3 magnets onto the oil pan sub-assembly, in the portions indicated in the illustration.
![]() |
Apply FIPG to the oil pan, as shown in the illustration.
Install the oil pan sub-assembly with the 19 bolts.
| 5. INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY |
![]() |
Coat new O-ring with ATF and install it onto the oil filler tube.
Install the oil filler tube with the 2 bolts.
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 7. ADD AUTOMATIC TRANSMISSION FLUID |
| 8. INSPECT AUTOMATIC TRANSMISSION FLUID |
![]() |
Park the vehicle on a level surface and engage the parking brake.
With the engine idling and the brake pedal depressed, shift the shift lever into all positions from P to L, and then return it to the P position.
Pull out the oil level gage and wipe it clean.
Push it back fully into the pipe.
Pull it out and check that the fluid level is within the HOT range.
If there is any leakage, repair or replace O-rings, FIPGs, oil seals, plugs or other parts.