Home › TRANSMISSION ยท A340E AUTOMATIC TRANSMISSION › TRANSMISSION WIRE

TRANSMISSION WIRE > REMOVAL

for Preparation Click here


CAUTION:
When working with FIPG material, you must observe the following guidelines.

  1. Using a razor blade and gasket scraper, remove all the old FIPG material from the gasket surfaces.
  2. Thoroughly clean all components to remove all loose material.
  3. Clean both sealing surfaces with a non-residue solvent.
  4. Apply FIPG in an approximately 1 mm (0.04 in.) wide bead along the sealing surface.
  5. Parts must be assembled within 10 minutes of application. Otherwise, the FIPG material must be removed and reapplied.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. DRAIN AUTOMATIC TRANSMISSION FLUID
  1. Remove the drain plug, gasket and drain ATF.

  1. Install a new gasket and drain plug.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }



3. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY


F050819
  1. Remove the 2 bolts and oil filler tube.



4. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


D028705

NOTICE:
Some fluid will remain in the oil pan.

  1. Remove the 19 bolts and oil pan sub-assembly.



    Q007487E01
  1. Insert the blade of SST between the transmission case and oil pan, cut off applied sealer and remove the oil pan.

    SST
    09032-00100  

    NOTICE:
    When removing the oil pan, be careful not to damage the oil pan flange.



    AT00103
  1. Examine the particles in the pan.

    1. Remove the magnets and use them to collect steel particles. Carefully inspect the foreign matter and particles in the pan and on the magnets to anticipate the type of wear you will find in the transmission.
      Steel (magnetic) ... bearing, gear and clutch plate wear
      Brass (non-magnetic) ... bushing wear



5. REMOVE VALVE BODY OIL STRAINER ASSEMBLY


D028706
  1. Remove the 4 bolts and oil strainer.

    NOTICE:
    Be careful as some fluid will come out of the oil strainer.

  1. Remove the 5 gaskets from the oil strainer.



6. REMOVE TRANSMISSION WIRE


D029778E03
  1. Disconnect the 4 connectors from each shift solenoid valve.



    AT05066
  1. Remove the bolt and the stopper plate from the case.

  1. Pull the solenoid wiring out of the transmission case.

  1. Remove the O-ring from the solenoid wiring.