FLOOR SHIFT ASSEMBLY > INSTALLATION |
| 1. INSTALL FLOOR SHIFT ASSEMBLY |
![]() |
Install the floor shift with the 4 bolts.
Connect the 2 clamps and 2 connectors.
| 2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
CABLE TYPE:
Connect the transmission control cable with the clip to floor shift assembly.
Install the transmission control cable onto the floor shift assembly.
| 3. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY |
![]() |
ROD TYPE:
Install the floor shift gear shifting rod with nut.
| 4. REMOVE FRONT CONSOLE BOX (for Bench Seat Type) |
![]() |
Engage the 2 clips and claw, and install the front console box.
Install the clip and 2 bolts <A>.
![]() |
Install the No. 2 box bottom mat.
Install the instrument panel cup holder.
Install the box bottom mat.
Install the shift knob.
| 5. INSTALL FRONT CONSOLE BOX (for Separate Seat Type) |
![]() |
Engage the 2 clips and claw, and install the front console box.
Install the 2 screws <F>.
| 6. INSTALL INSTRUMENT PANEL CUP HOLDER TRAY (for Separate Seat Type) |
![]() |
Engage the 2 clips and 4 claws, and install the instrument panel cup holder tray.
| 7. INSTALL REAR CONSOLE BOX ASSEMBLY (for Separate Seat Type) |
![]() |
Engage the 4 claws and install the console box rear.
Install the 2 screws <F> and 2 bolts <B>.
![]() |
Install the console box carpet.
| 8. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY (for Separate Seat Type) |
![]() |
Engage the 6 clips and claw, and remove the console upper rear panel.
Install the shift knob.
| 9. ADJUST SHIFT LEVER POSITION |
![]() |
Push the control shaft fully rearward.
Turn the control shaft lever 2 notches counterclockwise to the N position.
Set the shift lever to the N position.
| 10. INSPECT SHIFT LEVER POSITION |
Check that the shift lever moves smoothly and appropriately from the P to R position, only when the ignition switch is turned to ON and the brake pedal is depressed.
When starting the engine, make sure that the vehicle moves forward when shifting the lever from the N to D position and moves rearward when shifting the lever to the R position.