Home › TRANSMISSION ยท A750F AUTOMATIC TRANSMISSION › TRANSMISSION CONTROL CABLE

TRANSMISSION CONTROL CABLE > INSTALLATION

for Preparation Click here



1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY


F050822
  1. Install the transmission control cable assembly with the nut.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }

  1. Install the transmission control cable bracket and lock plate.



    F050835
  1. Connect the transmission control cable with the nut to the body.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }



    F050834
  1. Connect the transmission control cable with the 2 nuts to the body.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }



    F050833
  1. Connect the transmission control cable with the lock plate to the floor shift assembly.

  1. Install the transmission control cable onto the floor shift assembly.



2. INSTALL VOLTAGE INVERTER ASSEMBLY (w/ Voltage Inverter)


E075970E01
  1. Connect the 2 connectors and install the 2 wire harness clamps.



    E075965E01
  1. Install the 6 bolts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf } for bolt A

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf } for bolt B



3. INSTALL CONSOLE BOX FRONT


    B085777E01
  1. Engage the 2 clips and claw, and install the front console box.

  1. Install the 2 screws <F>.



4. INSTALL INSTRUMENT PANEL CUP HOLDER TRAY


    B085773E01
  1. Engage the 2 clips and 4 claws, and install the instrument panel cup holder tray.



5. INSTALL CONSOLE BOX ASSEMBLY REAR


    B085820E01
  1. Engage the 4 claws and install the console box rear.

  1. Install the 2 screws <F> and 2 bolts <B>.



    B085771E01
  1. Install the console box carpet.



6. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY


    B085769E01
  1. Engage the 6 clips and claw, and remove the console upper rear panel.

  1. Install the shift knob.



7. ADJUST SHIFT LEVER POSITION


D028682E02
  1. Push the control shaft fully rearward.

  1. Turn the control shaft lever 2 notches counterclockwise to the N position.

  1. Set the shift lever to the N position.



8. INSPECT SHIFT LEVER POSITION
  1. Check that the shift lever moves smoothly and appropriately from the P to R position, only when the ignition switch is turned to ON and the brake pedal is depressed.

  1. When starting the engine, make sure that the vehicle moves forward when shifting the lever from the N to D position and moves rearward when shifting the lever to the R position.